This is the same as SAG mills man, I don't get bonus output from steel balls but it's processing faster. This setup pulverizes about 8 rods per second meaning it produces just about 12,288 EMC per second in a 3x3x3 space. The yellorium quest requires 640,000 yellorium ingots at 65,536 EMC each which is just under 42 billion EMC. Using my setup, it takes 3,413,333 seconds to make that much EMC, which is 56,889 minutes, which is 948 hours or about 39 and a half days.
If I were you I would make multiple sets of 4 Sag Mills feeding the Powder into the Chest (You may have the same setup as posted here)
M=Mills
C=Condenser
x=Open air
xMx
MCM
xMx
Chest in the center and the Mills around it, the mills push the powder into the condenser (Not using the Conduits to feed them in) which is set to fabricate blaze rods, then placing Ender IO Item Conduits above the condenser, the one above the condenser set to extract and filter blaze rods and back into the Mills. Having them all on the same platform in a line with Item Conduits on the bottom of the Energy Condensers set with a redstone signal with Wireless Transmitters from WR-CBE Logic to purge the system when you want to start extraction for other EMC purposes; this should be until you get the MK2 Condenser in which the Daisy Chain Cobblejack strategy would go into play since the MK2 will generate EMC quicker as it consumes stacks more quickly. The Transfer nodes will generate 256 EMC every second when the World Interaction Upgrades are a full stack in the Nodes. Compare it to the Blaze Powder which will take longer to fabricate, even with the Mills using the Dark Steel Balls.
Do not just have one set of Mills, if you really want EMC fast, you need multiple sets of them and for them to be wired to be purged via redstone signal in the conduits when you want the EMC instead of having to switch each item in the condensers. If power is an issue, create Tesseracts to help with that, You should have the Enderium and other resources available to make the Frames which can be created using EMC after having the table learn it.
Picture included is the basic setup I made in a few minutes (Just added the 8x Furnace Gen for basic power until I get the Power Plant operational)
Last edited: