So I'm getting set to create a couple multiblock farms, and I'd like to be able to mass produce the blocks with AE. Most of the recipes are straightforward, but the electron tubes are looking a bit tricky. Specifically, I have no idea how you're supposed to automate the Thermionic Fabricator. From my initial experiments, it looks like I can use routers to insert material into specific slots, but trying to insert materials based on a side just throws them into slot 0, where the glass is supposed to go. While I can technically use an array of 9 routers to insert the correct number of materials into each slot, keep the glass stocked, and remove the outputs, this seems a little awkward. I'm fine with dedicating a fabricator to a single kind of tube, though, since I'll probably just need tin and bronze tubes in any real quantity.
Thermionic Fabricator Automation
- Thread starter CodaPDX
- Start date
-
The FTB Forum is now read-only, and is here as an archive. To participate in our community discussions, please join our Discord! https://ftb.team/discord
Have you tried the bottom or top? I just looked on the forestry wiki and there's nothing there about pipes and sides for the thermionic fabricator - I guess Sengir didn't think anyone would want to keep it heated up all the time. Does the side work for removing the tubes, or does that just remove glass?
You can attach an interface directly to the fabricator and pull from the bottom (haven't tested other sides) with an import bus.
That's extremely helpful. Thanks. I'll just use a router with a machine filter to keep the top slot stocked with glass, and that should do the trick.
A router can insert into a specific slot number. 3 routers should do the job. 2 for inserting, 1 for extracting?
You can attach an interface directly to the fabricator and pull from the bottom (haven't tested other sides) with an import bus.
Instead of the separate tesseract for the sand, you could put an export bus on top of the fabricator that would do the same thing.
You can edit the "Slot 0" field in the router interface. Keep incrementing that number until you put something in the router and it disappears, then go look at the fabricator and see where it went. Make a note, increment again until you have the numbers for every slot in the machine.
Finished?...I've only just gotten here.
Dunno if this changes with different versions of the modpacks or different versions of Forestry/Factorization but here's what I've discovered IRT how the ThermoFab translates to the Router:
name: 'factory2.0'
Sand: slot 0
recipe: slots 3-11
internal inventory: slots 12-29
output: ?
With a recipe loaded in the ThermoFab [and sand, power] and sufficient materials to craft in the internal storage, I cannot get the Router to extract from the output slot [and I've incremented past 100]. I'm trying to build one for each tube type, in as compact a build as possible and as material efficient a build as possible.
I'll be using an ME Interface with each ThermoFab so AE knows which machine is which. Router to keep all machines topped-off with sand. A Router to extract would make more sense than an import bus for each ThermoFab [and be easier to wire, keeping asthetics in mind].
Has anyone gotten a Router to successfully extract from this machine? I'm stumped as to why mine isn't working.