I have not found a single topic that would cover this problem neither found where could I report it directly to the developer, so perhaps we can solve it here.
I was testing out the transformers from the RP2 with the 10kW wire and it seems to be broken.
Powering let's say blulectric engine can be done with two solar panels hooked up directly into it with normal wire. But when using transformers there is huge energy leak.
Also transformers will consume most of the energy of the battery even if they are in dead end cable line that just ends without any device.
Also the output A is fairly low after transforming the current back to the low voltage.
I was trying to find some wiki or howto on these but the only thing I found was video from Direwolf and he just barely mentions the transformers.
So I would like to know what to do with transformers to have them work properly or if I should wait for update and what else can mess the current because even the batteries don't have stable output and it goes from 0,2 to 12A... Makes no sense for me at all.
I was testing out the transformers from the RP2 with the 10kW wire and it seems to be broken.
Powering let's say blulectric engine can be done with two solar panels hooked up directly into it with normal wire. But when using transformers there is huge energy leak.
Also transformers will consume most of the energy of the battery even if they are in dead end cable line that just ends without any device.
Also the output A is fairly low after transforming the current back to the low voltage.
I was trying to find some wiki or howto on these but the only thing I found was video from Direwolf and he just barely mentions the transformers.
So I would like to know what to do with transformers to have them work properly or if I should wait for update and what else can mess the current because even the batteries don't have stable output and it goes from 0,2 to 12A... Makes no sense for me at all.