Off button?

[Torigoma]

I'm messing around with the MFFS, but I need a little help. I had once made a system using the wireless Redstone transmitters to make it so I can have the force field on, hit a button, it turns off for a second, I slip through and it reactivates. But I can't remember how I did it, does anyone know how this can be done?

 

[lazaruz76]

Button, wire, state cell, not gate, wire, mffs block. Quick and simple.

Wireless version:
Reciever, state cell, not gate, mffs block

If you go wireless use private channels.
Wireless sniffer allows you to make a channel private I think.

 

[Wekmor]

Power the mffs projector with a redstone torch, turn it off for a short time via a button?

 

[lazaruz76]

That would be the same as using a red power not gate. It would work only difference is in execution.

 

[TangentialThreat]

My base uses wireless remote > wireless receiver > toggle latch (or any other T flip-flop thing) > projector. This is much more convenient than needing to hit a button and you can keep the shield down for as long as you want.

 

[Ako_the_Builder]

Button, wire, state cell, not gate, wire, mffs block. Quick and simple.

This is the same as my set up but without the state cell, there is a delay built in to the mffs which makes it drop for about 2 seconds just off the button press (cursor is pointed at the mffs projector).

To make it wireless just swap the red alloy wire for a wireless receiver.

 

[Wekmor]

That would be the same as using a red power not gate. It would work only difference is in execution.

Good to know, not too familiar with all those different gates :s