I have an area in my base where there are warp itemducts and I was wondering what ways you guys would go about covering them without making the floor look bad, because facades don't have connected textures. Here is a screen shot. The warp itemducts have to be floor level because the flux ducts are too high up.
Covering itemducts with no connected facade texture
- Thread starter mattp_12
- Start date
-
The FTB Forum is now read-only, and is here as an archive. To participate in our community discussions, please join our Discord! https://ftb.team/discord
You could use a flux item duct( carry power and items in one duct) where your power and item ducts cross so that you can lower them 1 block to be below the floor. Don't really have any other ideas
Yeah, place the warp itemduct where the fluxducts and itemducts cross. Then you can have the whole thing lower.
No, but flux-warp-itemducts do.
It's one of the variations; all itemducts have opaque, transparent, dense, vacuum, and flux varieties, and maybe some others I'm forgetting. They have tooltips explaining their uses.
Actually fluctuating warp item ducts aren't a thing. I hope RWTemma adds them in :3
Sent from my Thingy using a Thingy.
Sent from my Thingy using a Thingy.
Huh. Are you using the latest version? I could have sworn I saw every version for every conduit... Just out of curiosity, can't you just route your power cables lower?
I could, but I want this thread to give me ideas on what I could do that's not necessarily the easiest or most convenient way. I want to do something that's not as simple as just lowering a wire.
change your floor to a checkerboard pattern then it doesn't matter that facades don't have connected textures(neither will the rest of your floor)
