• The FTB Forum is now read-only, and is here as an archive. To participate in our community discussions, please join our Discord! https://ftb.team/discord

Buildcraft Pump depth?

Flexico

Well-Known Member
I'm trying to pump up an oil geyser, but my pump keeps stopping after about 7 blocks down (the pipe disappears). Have the pumps been nerfed in the new version (6.0.18), and if so, what's the alternative for pumping out an underground reserve?
 
Yeah, it stops pumping, and a gate even reads it as "work done". :\ And then, after about a minute, the pipe starts coming out of the bottom uf the pump again, and then when it gets close to the oil, it disappears again. Later, rinse, repeat.
 
Is there another fluid around? If you are in the ocean, isolate the oil by building a column from the floor to the surface with only oil inside. The pump may be picking up the alternative fluid and getting confused.

Sent from my SCH-I535 using Tapatalk
 
It's far above the water, not even getting halfway down the geyser.
41NV13i.png

Yes, I have tried breaking/replacing, and it's getting constant power from a sterling engine.
 
Back
Top