Best and Most Efficient Way to Convert RF to EU?

[RoyalCreeper12]

I've always had a surplus of RF and not enough EU. So I decided to convert RF to EU. Right now I am using Hydraulicraft with Redstone Pump feeding into a Hydraulic Generator. However, I've been wondering if there is a better way to convert RF to EU. Any help would be appreciated.

 

[Revemohl]

Power Converters or Engineer's Toolbox.

 

[Geometry]

There is also the less known method of turning RF into MJ via energy conduits and then feeding that into an electrical engine from forestry.

 

[YX33A]

There is also the less known method of turning RF into MJ via energy conduits and then feeding that into an electrical engine from forestry.

Easier then using Engineers Toolbox, but less efficient for sure.
As far as I can tell, not a lot of options exist to change between them, and @Revemohl covered both lossless ones.

 

[Not_Steve]

Mekanism universal cable is another option. The newest update apparently fixed the issues.

 

[Mirality]

I haven't tried this, but you could try making an Oil Fabricator, and then do the usual to make EU from the oil. But I usually just make Steam Turbines when I want EU.

 

[Not_Steve]

I haven't tried this, but you could try making an Oil Fabricator, and then do the usual to make EU from the oil. But I usually just make Steam Turbines when I want EU.

That's incredibly wasteful. First you should run it through a refinery and turn it into fuel and then you come out power neutral

 

[Mirality]

That's incredibly wasteful. First you should run it through a refinery and turn it into fuel and then you come out power neutral

That's what I meant by "the usual".

 

[YX33A]

That's incredibly wasteful. First you should run it through a refinery and turn it into fuel and then you come out power neutral

Power neutral? You can do a bit better then that if you're smart...
And has Emashers Mods installed.

 

[asb3pe]

I am playing Monster and I just noticed that the Power Converters mod is present in the modpack. However, I also remember reading a thread on here that warned that the power converters mod is horribly buggy and also that the mod was never going to be updated, ever again. In other words... use with caution? Can anyone confirm or refute? The mod worked perfectly for me in Ultimate modpack, and it was a real lifesaver!

Right now I have 125 compression dynamos for my RF (that's 10,000 RF/t) and I have 64 semifluid generations for my EU (that's 2048 EU/t) so I don't think I'll ever need to convert between the two... especially when I left room in my "power dome" for another 125 dynamos and another 64 semifluids.

The nice place where conversion comes into play is EU->RF->send thru tesseract->EU so you don't need any glass fibre cable.