Problem XNet-AE2 Compatibility lack? University 1.16

  • Tech Support section is for getting help with FTB related problems. If there's a repeatable issue that can be labeled as a bug, then please use the issue tracker for the pack or the app at GitHub issue trackers - If there's no repository for a pack that means that the pack is old and/or will not be updated. Bugs for older packs will not be fixed, unless they are critical.
  • The FTB Forum is now read-only, and is here as an archive. To participate in our community discussions, please join our Discord! https://ftb.team/discord
G

gsthomsen

New Member
Oct 16, 2022
2
0
2
Hello, I've been attempting to connect my functioning and powered ME system to my XNet system for the better part of thirty minutes. I have tried to use connectors on every part of the AE2 ME System structure, "Controller, Drive and Terminal" Doing this does yield results in the XNet controller so far as to say that it shows up as a block on the network. The problem is, that I am unable to extract or insert any items from inside my ME system to any other blocks connected to the same network. I did some troubleshooting to make sure I was using the correct settings, but attempting a far more basic transfer of items from a storage drawer to a chest, with success. I wonder if it is possible that there is simply compatibility lacking between the two mods.
 
So, should anyone else be struggling with this, then I have not a solution but a workaround.
The ME Storage Bus, acting as external storage can connect to a drawer controller. The items you wish to have transported by the XNet, you simply store in drawers connected to the controller. The XNet has no problem dragging and dropping items from the drawers mod which can in turn be connected to your ME system and be displayed as storage in the terminal.
Best of luck to anyone trying to wrap their heads around this annoyance.
 
You must log in or register to reply here.
Top Bottom