So I want to push uu liquid out from a fabricator and into a RC tank. Tried using a fluid duct, and my uu matter just disappeared. Am I going to need a gated bc pipe for this? I can't seem to find anything other than fab to replicator tutorials...
uu liquid processing
- Thread starter DREVL
- Start date
-
The FTB Forum is now read-only, and is here as an archive. To participate in our community discussions, please join our Discord! https://ftb.team/discord
I might get a pic 12 hours from now... until then, there isn't anything special here. Liquiduct with a pneumat servo connected to the massfab with the arrow pointed away from the massfab and powered.
0uu in mass fab
0uu in duct
0uu in rc tank
One source says use the ic2 ejector upgrade for the mass fab. Probably will do that.
0uu in mass fab
0uu in duct
0uu in rc tank
One source says use the ic2 ejector upgrade for the mass fab. Probably will do that.
No pictures neccisary. Once again slight derp. The extruding ducts from the mass were empty. The RC tank was empty. The mass fab was empty after 1 full uu cycle. What I didn't realize is that I had ducts exiting the RC tank powered ready for me to install the replicator. That's where al my made uu matter was lol.