Thaumcraft: No Aura by Silverwood Trees

[zaph_b]

Hey all,

I am using the mindcrack pack, and I created the wand of the apprentice but it would not charge at my base. I know it was a possibility I did not have a node by my base so I went off to find somewhere near my base that could charge my wand. Within 125 blocks I found two Silverwood trees, but when I stood near both, neither one would charge my wand. I thought that all Silverwoods had nodes within them and thus there should be some vis in the area. Am I mistaken or is there something else at work here?

NOTE I did find an area that could charge my wand in another direction and will set my thaumcraft base of operations there. I just could not find any discussions with folks with similar issues.

 

[Bickers]

had this problem twice and had to regen my aura nodes unsure what causes it just change in the config B:aura_nodes to true and change regen key then walk around your base once there fixed set it back to false

 

[knight2109]

I had this problem when updating to the new version. Even restoring a backup file I had downloaded before updating the server the problem persisted. All newly generated ones seem to be fine though.

 

[zaph_b]

Thanks for the advise!

 

[tehBlobLord]

I also had exactly the same problem, but as we are on a server I couldn't do anything about it.
My base is huge and only the GT multiblocks (industrial blast furnace etc) room has aura.

 

[Jugg3rV]

I have this problem, too. Started regeneration of the world again without success. It spawns nodes like 250-300 blocks away but not at my base. So i would like to know if there is a way to spawn a node via console.

 

[Bickers]

make sure you change the regen key or it wont work then just load your world around run around your area you should see alot of messages in the console window then turn it back to off once its done