Specific RS Latch setup needed

[SReject]

Ok, I need an RS latch setup such as:

-A-
D-B
-C-

Where:
A & B are inputs
C & D are outputs

If A is on, C is on
If B is on, D is on.

I was fiddling with redpower 2's RS latch, but couldn't get it setup to where the inputs where adjacent to each other, and the outputs were adjacent to each other.

Am I missing something? or am I going to have to use a vanilla version to achieve what I need

 

[Abdiel]

If you have space, just use the RP latch and cross the wires using a Null Cell.

If you need it in a 3x3 area, I'm afraid that's likely impossible.

 

[SReject]

If you need it in a 3x3 area, I'm afraid that's likely impossible.

I feel as though that's a challenge (LOL, just kidding sorta...)

 

[SReject]

Here's a vanilla, 2W x 3L x 3T (excluding output block placement):

 

[Abdiel]

I don't know if this isn't bending the requirements a little...

 

[SReject]

I don't know if this isn't bending the requirements a little...

Very nice +1 like from me

Q: is the white line just a micro block for seperation?

 

[Abdiel]

Q: is the white line just a micro block for seperation?

Correct.

Note that if you don't need the outputs in those specific location, just in that order, the design is only 2x2 (use the top right corner).

 

[SReject]

jacketed wire my friend....

 

[Abdiel]

True, that works too. Personal preference.

 

[SReject]

True, that works too. Personal preference.

Wool is cheap, diamond saws not so much, LOL

 

[Abdiel]

You can cut microblocks with any saw. The only thing you need a diamond one for is silicon wafers.