[SOLVED]Issues with AE sorting System(FTB Ultimate)

[Peppe]

I only had one to originally test the system out to see if it would work



Yes I do, it was attached to the system the whole time with power.

Does the controller show the right count of busses? Might tell you if there is break in your cable somewhere.

 

[Bickers]

I only had one to originally test the system out to see if it would work



Yes I do, it was attached to the system the whole time with power.

so long as you have a chest to accept the items it should work i also tested it in my test world and your system worked fine

 

[Ardor]

so long as you have a chest to accept the items it should work i also tested it in my test world and your system worked fine

Were all of your chests formatted or not active? During my testing, only 3 formatted chests were active, no regular chests[DOUBLEPOST=1368512398][/DOUBLEPOST]

Does the controller show the right count of busses? Might tell you if there is break in your cable somewhere.

And yes it did show the right number.

 

[Bickers]

i used a unformatted chest

 

[PonyKuu]

Formatted/unformatted doesn't matter I think.
Also, you don't need to connect a cable to each chest - connection to one chest should be enough, 'cause adjacent devices connect to the same network

If you didn't have any place for ores in your network - that might be an issue. You can make a small storage cell for them.

Also, why use chests when you can use a drive bay with preformatted disks and Access/Crafting Terminal? I think that's even cheaper since each chest requires a conversion matrix...

 

[Peppe]

I think he figured it out.

Sounds like he had the ores in the ender chest with just an import bus. Then an export bus for the ores on the pulverizer, but only pre-formatted disks in his chest with no ores. AE won't pull direct from an import bus to deliver to an export bus. It has to import to storage, then export.

 

[Ardor]

I think he figured it out.

Sounds like he had the ores in the ender chest with just an import bus. Then an export bus for the ores on the pulverizer, but only pre-formatted disks in his chest with no ores. AE won't pull direct from an import bus to deliver to an export bus. It has to import to storage, then export.

Exactly.

Formatted/unformatted doesn't matter I think.
Also, you don't need to connect a cable to each chest - connection to one chest should be enough, 'cause adjacent devices connect to the same network

If you didn't have any place for ores in your network - that might be an issue. You can make a small storage cell for them.

Also, why use chests when you can use a drive bay with preformatted disks and Access/Crafting Terminal? I think that's even cheaper since each chest requires a conversion matrix...

I wanted to, but my friend would rather have chests :/

 

[PonyKuu]

I wanted to, but my friend would rather have chests :/

Well, you stil can add Access or Crafting Terminal. Not a big difference, to be honest :3