[Reactorcraft] Fusionplasma flows out

[Tabasco]

Hi!
I have a Problem with my Fusion reactor.
It works and it makes very much power but the Plasma escapes every few seconds like the picture below

http://img4web.com/view/2S3TVW

3 of the 4 plasma injectors are not connected to the plasma preheater.
the Solenoid Magnet receives 2048 Torque and 4096 Speed from a Magnetostatic engine with a 16:1 Gearbox on Torque mode.

the Toroids gets 2x 4096 Torque and Speed from 2 Magnetostatic engines. How much need them to create a circle of bolts without interrupts?

Whats the problem with my concept?

 

[Wagon153]

Are your van de graafs receiving enough power, and is there enough of them? 1 per quadrant of the reactor is the minimum requirement.

 

[Tabasco]

1 per Quadrant? I have 2 magnetostatic on 4096 * 4096 on 2 corners. All Lightnings are Purple and only on the next van de graaf is a hole between 2 toroids

 

[Wagon153]

Hmm. And you say the problem only happens every few seconds. If it looks normal the rest of the time/the plasma does nothing, then don't worry about it. There have been visual glitches with the fusion reactor in the past.

 

[Tabasco]

Ah ok. May it comes from lag? Every time it lags the Plasma get this formation.
Why in the past? I got version 25z.

Does it makes a difference to speed up the solenoid?

How much High pressure turbines can be powered by the fusion reactor? I got 1 HP and 1 Plasma injector and cant consume that much steam.


Thnx for help

 

[Wagon153]

Ah ok. May it comes from lag? Every time it lags the Plasma get this formation.
Why in the past? I got version 25z.

Does it makes a difference to speed up the solenoid?

How much High pressure turbines can be powered by the fusion reactor? I got 1 HP and 1 Plasma injector and cant consume that much steam.


Thnx for help

Yes I believe lag does have a large part of it. And as for the turbines, in Reika's world tour videos, he had several turbines and said he could add on more if needed.

 

[EyeDeck]

The issue you're describing is just lag, nothing to worry about.

How much High pressure turbines can be powered by the fusion reactor? I got 1 HP and 1 Plasma injector and cant consume that much steam.

With all 4 injectors hooked up to a single preheater, my experience is that a RoC fusion reactor will comfortably power 6 high-pressure turbines. I can't see any reason not to run a magnetic containment pipe around to the other three injectors, but to each their own.

 

[Tabasco]

The reason was that i dont had enough water and only 1 turbine. Now they are connected and i got 3 Turbines. 2 full barrels of steel is really hard even with a quarry and 2 laserdrills on a maxspeed extractor on all stages... i think with 10 normal turbines i got more RF than with 1 High pressure but they dont look so cool and takes much more Space ^^