Problem with automated inscribers

[NonixDark]

Hi all!
I'm having a problem with my automated inscribers. I've made autocrafting recipes for every processor and component. It's connected to my AE-system and almost everything works like a charm... Except for one thing. The fifth and final inscriber where all finished processors are made. I've put an import bus on the side where the final product is supposed to be imported to the system, forwarded from the inscriber. But when the import bus is there the inscriber won't work. It recieves all the components it needs to make the processors but it doesnt't make anything out of it. The ingredients just stay there as if waiting for better days or at least waiting for the inscriber to get powered up. Thing is, though, that when I take the import bus out of it starts working and finishes the product.. Which then stays there in the inscriber. When I put the import bus on the same side again the processor is imported to the AE-system but the next processor won't be produced until I take the import bus out again and repeats this to infinity (no pun intended).

What do I do wrong and how can I make it right?

Skickat från min LG-D855 via Tapatalk

 

[MacAisling]

The busses do not transfer power. You need 1 face touching a cable or full block AE2 device.

 

[Someone Else 37]

The busses do not transfer power. You need 1 face touching a cable or full block AE2 device.

Also worth noting that inscribers, like other AE2 machines, will transfer power to each other. If you've got all your Inscribers in a line, attaching a cable to any one of them will power them all. The full-block ME Interfaces transfer power as well, so if your system is set up to craft circuits on demand and you're using the flat-panel Interfaces to supply the ingredients, swapping them out for the full-block versions will also work.