Hey mates, got a little problem. My Auto Enchantment Table isn't receiving any Liquid Experience from my Thermal Expansion Tank. Here is my setup. http://imgur.com/a/gQPOT
Am I missing something simple?
Am I missing something simple?
OpenBlocks Auto Enchantment Table Help!
- Thread starter shankynation
- Start date
-
The FTB Forum is now read-only, and is here as an archive. To participate in our community discussions, please join our Discord! https://ftb.team/discord
All the pipes seem full of liquid XP like they ought to be.
Just double-checking to make sure I see the whole system. Drain to OB tanks, to fluiducts, to portable tank, to more fluiducts, to auto-enchanter.
Are the two sets of fluiducts isolated from each other? I think the images show they are, but I just want to double check. Also, what does the GUI for the auto-enchanter look like?
Just double-checking to make sure I see the whole system. Drain to OB tanks, to fluiducts, to portable tank, to more fluiducts, to auto-enchanter.
Are the two sets of fluiducts isolated from each other? I think the images show they are, but I just want to double check. Also, what does the GUI for the auto-enchanter look like?
The Auto-enchanting table tabs to the right are where you configure it. For each of the tabs you can left-click to set the side which determines where that action goes and right-click to rotate the angle of the viewing of the table.
The one you are looking for is the bottom tab. Check 'Auto Drink' on that tab, then rotate the table to the side you want it to input and then left-click the placement where you want it to drink from.
Hope this helps!
The one you are looking for is the bottom tab. Check 'Auto Drink' on that tab, then rotate the table to the side you want it to input and then left-click the placement where you want it to drink from.
Hope this helps!