My Modest Assembly Table Setup - Tips?

  • Please make sure you are posting in the correct place. Server ads go here and modpack bugs go here
  • The FTB Forum is now read-only, and is here as an archive. To participate in our community discussions, please join our Discord! https://ftb.team/discord
Bigglesworth

Bigglesworth

New Member
Jul 29, 2019
1,072
0
1
MKgjW40.png


*cackle*
Diamond gates in under 2.2 seconds.
 
  • Like
Reactions: Setari, Korenn and AlanEsh
B

budge

New Member
Jul 29, 2019
273
0
0
Those lasers are yellow. Did you just start it up, or is there still plenty of room for moar power?
 
Bigglesworth

Bigglesworth

New Member
Jul 29, 2019
1,072
0
1
It can get to 3800+ but I misclicked and had to replace the assembly table itself, and now it stays at what is shown for as long as there is ample power. Not sure why, but Ill look at it later maybe.

With a doorway in and out of the superassemblycube it (did) stay around 3760~
 
Bigglesworth

Bigglesworth

New Member
Jul 29, 2019
1,072
0
1
vineet said:
Um how are you supplying such power?
Looks amazing
Click to expand...
Redstone energy cubes+conduits. The setup would have its own electric engine array hooked into my EU grid. Redstone + gate set to send a signal when the energy cubes arnt full to the engine array to power them on/off when not needed. Only did this for fun and to see if i could break 4000MJ/t.This here can reach 3800, and I have not spent much time after making it to see if i can get clever with wireing somehow to get to 4k. I'd like to see someone do it.
 
You must log in or register to reply here.
Top Bottom