My industrial squeezer is working and using IF but isnt doing the processes

[GeckoG4ming]

Ive just set up an Immersive engineering industrial squeezer to automate menril logs into menril resin into menril blocks. However for some reason when the machine is using IF and the animation showing it is working is displayed, in the machine interface it isnt squeezing the menril logs and outputting resin, is there a fix for this???

 

[GeckoG4ming]

Update: It does seem to be working now however it only crushes one log every 30s - 1min which is too slow, is there a way to speed it up?

 

[Cptqrk]

The squeezer is a bit of an energy hog, your problem was probably not enough power to get it going, and now that it's working, you are probably choking on power. Try pumping more power into it via HV wires, or some other form of energy transfer.