MFR Laser Drill bug?

[PierceSG]

I will try to keep this short.

1. Standard 4 Prechargers to one Laser Drill setup.
2. TE's Tesseract right on the Laser Drill. Set to receive energy and send items. Redstone Energy Conduits from 4 sides of the Tesseract into the Prechargers.
3. Now the problem. The Laser Drill will work for like 2 times, meaning the green work bar will go from empty to full. Then it will stop working and the red power bar of the Laser Drill will go from empty to full and stays there while the green work bar will not move at all.

Additional information.
1. Power is received from my Atomic Science's Fusion Reactor with 9x9 large Reactor Turbines into 1 TE3's Tesseract set to energy sending only.
2. Fusion Reactor is set to run non-stop, fed by 4 Chemical Extractor making Deuterium.

So, does feeding too much power breaks the MFR's Laser Drill? Since I had been powering it with 20 Magmatic Dynamo previously and it works, if not somewhat slowly, without a hitch before I switch the channel over to my Fusion Reactor.

Edit: I did test it over and over again by changing the channels of the Tesseract and it will always work when on the dynamos but will stall when switched to the fusion reactor.

Sent from my GT-N8020 using Tapatalk

 

[SkyBoy96]

Is there anywhere for the items to go on the fusion reactor channel? If there isn't, the tesseract will fill its internal buffer of 1 slot, then the drill will fill its buffer of 1 spot and halt operations until it is cleared.

 

[PierceSG]

Hmm....You might be right, I must have forgotten to change the receiving side's channel. /facepalm

Edit: Yup, a major derp on my part. I didn't change the channel for the receiving side....