Having issues with industrial coil/Blast Furnace (Rotary Craft)

[Brave Raccoon]

Guys, please, help me out anyone because I spend 2 days and can't find any solution.

1) I can't make Inudustrial Cil charging. I saw on one forum that since one of the versions it requires minimal input BUT I tried to charge Industrial Coil with charged Industrial Coil in creative: I set the output speed/torque at 1000/10000/50000 and it just receives energy for one second and thet's all! (at 50000 output it received 500MJ in 1 second and stops receiving anything). I don't understand what to do :c

2) I need Industrial Coil for Blast Burnace. I tried 4 Gasoline Engines connected or 4 AC Electric Engines connected (only 1100 degree when need 1150). Maybe I suck at this and don't know how to use Gearboxes properly.

Well, if u help me to undestand how to make Industrial Coild work then it solves everything.

Rotary Craft version is 1.7.10 V7f

Please help me, guys! Thanks in advance!

 

[Celestialphoenix]

Try using a more powerful engine- such as performance engines, or a Microturbine.

The coil may not work- as recipes which require higher temperatures take longer to smelt. (You're on an old version- not sure if its implemented)​

With the friction heater- equal amounts of speed and torque produce the highest temperatures.

(ie 256Nm at 256rad/s results in higher temperatures than 128Nm at 512rad/s)
​

Theres a handheld gadget called the angular transducer- very useful for measuring shaft power.

 

[Plasmasnake]

You can achieve 1150 degrees with 3 performance engines if need be. I personally prefer to use a microturbine geared for torque as you will need it later to smelt tungsten.

As for the coil, I believe you may be trying to charge a coil while you are using it, which you cannot do. You can either charge it or discharge it, but you cannot do both at the same time.

 

[Reika]

V7f