Bug EnderIO capacitors not outputting to Cryo-Stabilized Fluxduct.

[Bondlee]

So recently I have been playing on a FTB Infinity server and decided to replace all the RedNet cables I had (which transfer up to 1000RF maximum) with Cryo-Stabilized Fluxducts from thermal dynamics, since their RF/t transfer amount is unlimited. The Fluxducts transfer energy from a Vibrant Capacitor array that is charged with solar expansion's panels and after connecting the Fluxducts to the capacitor I have to reset its I/O configuration after leaving the area and returning again or else power is not outputted from the capacitor array to the ducts (the server doesn't keep the chunk loaded when players are not around to reduce lag). is there a way to fix this bug rather than having to re-configure the side where the duct is connected?

I have attached a link containing a gallery of the images regarding the setup and configuration:
https://postimg.org/gallery/th4y002g/

 

[KingTriaxx]

Try pulling the conduit, and setting the output, then reconnecting the conduit.

 

[Bondlee]

Try pulling the conduit, and setting the output, then reconnecting the conduit.

Nope. I reset it to output mode after removing the conduit and still didn't work after I reconnected the duct

 

[Bondlee]

Ok I managed to solve it by extending the conduit into the capacitor so that 3 sides of the capacitor touch the duct and placed a panel on top of the duct.