AE2 Priorities

[ZethHQ]

So I've ran into a problem that is least said bothering me. I set up a classic DSU storage room with storage buses on top of every unit. Set them to only accept cobble/netherrack/gravel/sand etc... this kind of stuff, and priority a lot higher than anything else, went from 1.000 to 3.000 then 10.000, hoping it will start working properly...wasn't the case. So here's a picture:

The thing on top is a tweaked SSD, a p2p tunnel - ME is connecting the controller with the white dense cable which is connected to the DSUs via interface -> storage bus. Even so, all the items will go into the ME System and not the DSUs... Am I missing something obvious?

EDIT: Okay...I reread my post after I posted it.. and I feel dumb as I forgot about the two buses connecting all the DSUs together... x_x

 

[Iluvalar]

I think AE tend to fill his current storage. If you have storage drive with cobblestone in it, it will first fill that one. The priority system is a bit off in that regard. I see 2 options..

1- export all of you cobble inside the DSU. Once every drive is empty of cobble it should work as intended.
2- Make a bit of cleaning a run all your drive inside an IO port. If you didn't format every cells, this might make a nice clean up and plenty of new space in your system. Since you have several DSU, I suggest this option.

 

[ljfa]

EDIT: Okay...I reread my post after I posted it.. and I feel dumb as I forgot about the two buses connecting all the DSUs together... x_x

Hehe
sometimes it's hard to keep track of which cable belongs to which subnetwork ^^

 

[ZethHQ]

Hehe
sometimes it's hard to keep track of which cable belongs to which subnetwork ^^

It really is and at first I didn't even want to touch AE2. But as I learned it I found out it is a lot of fun to play with.