2 ReactorCraft Designs

Discussion in 'Community Showcase' started by imPlayin, May 29, 2015.

  1. imPlayin

    imPlayin New Member

    Hey, I'd like to have some feedback on these 2 ReactorCraft Designs. I found them here on the forums, but I want to know how they perform on newer ReactorCraft versions. I hope the pictures are understandable.

    First one is a breeder:
    2015-05-29_16.03.40.png
    Second one is a standard fission reactor:
    2015-05-29_16.03.45.png

    Third is a shot of the whole complex:
    2015-05-29_16.04.43.png
     
  2. Pyure

    Pyure Not Totally Useless

    Looks good. Probably way more neutron-insulation than you really need but looks good.

    The quad-of-quads layout is very popular. I do this all the time with both breeders and regular fission reactors.

    I can't get a good look at your molten salt heat exchangers; just make sure you aren't overcooling them.
     
  3. imPlayin

    imPlayin New Member

    i just surrounded them with 8 steam boilers each. have no experience whether that's good or bad. How do you set up your Heat exchangers?
     
  4. Pyure

    Pyure Not Totally Useless

    If its a test world, tinker with using fewer. Don't output the steam into a turbine, pull it into a pipe segment with a pipe pump. Compare results with fewer and more boilers.

    If you use too many boilers, the water doesn't get high enough above 100C to create much steam.
     

Share This Page