1.0.3: Ender IO redstone conduits

Chance121710

New Member
Jul 29, 2019
2
0
0
Version:
1.0.3

What is the bug:
I cannot get the redstone conduits or the insulated redstone conduits to emit a signal to my drawbridges either directly connected or through another block

Mod & Version:


Paste.feed-the-beast.com log:


Can it be repeated:


Known Fix:
 

Jakalth

New Member
Jul 29, 2019
83
0
0
have too ask these to rule them out...

1: are both ends of the conduit set to the same color channel? Open hand or yeta wrench can change this, sometimes by accident.
2: is the whole length of the conduit connected to the same line? it's easy to miss a single length if your running them along other Ender IO conduits. I know I have.
3: have you tried using the lowly redstone dust as a connection buffer between the drawbridge and the redstone conduit? Or what about Project Red red alloy wire?
4: are you using a long redstone pulse? Like a button or lever? The short pulse from a timer, for example, will not trigger the drawbridge reliably unless it is lengthened by a repeater set at least half way(longer delay = longer pulse).
 

Chance121710

New Member
Jul 29, 2019
2
0
0
1. both ends are the same color i did check that. they were all set to red

2. yes it is the same line because it is only the redstone conduit

3. not yet because it is in the air. i havent tried the red alloy wires because i was going to use facades to cover the conduits.

4. I am using a lever