Recent content by BlinkY87

While I respect your post. Having tested FTB on the current host drive and on a separate drive I still gained an FPS advantage, using Ramdisk. It is worth noting that I will not employ Ramdisk for gaming since it can be regarded a hassle and there exists a possibility of a lost world since I...

I beg to differ, I had a 52% rise in FPS by experimenting with Ramdisk.

I tried recycling cobble (close to ten stacks) and got roughly four pieces of scrap. Waste of fuel. I find dirt gives me a better ratio, even leaves.

If your PC/laptop possess sufficient amount of RAM, then how about RamDisk?

HERE...Here...here

Could you, if possible, explain how you have the bio setup. From harvesting XYZ, to transporting (transporting isn't important for me, per say.)

I did. I know the mode key works because hover mode works with the electric jetpack. I can only assume it's our friend, Greg.

I'm capable of doing that and have been doing that though there is no indication that I am successfully in lossless.

It's this one: http://ftbwiki.org/Electric_Wrench I'm still relatively new to FTB so I'm unsure what is who's and who's is what. It says its IC.

I'm using the electric wrench and would like to enable lossless mode. I have the mode key bound to 'M' but there isn't a clear indication if I have enabled lossless and if it is even in lossless mode. Any suggestions?

VOLCANO'S!!!!! Having watched some Mindcrack videos, the new world generation does look refreshing (I'm sure Mojang had changed some aspects of it, right?) I'd probably say more populated areas. I'm not talking about increasing the quantity of villages but an abandoned village. The village has...

Cool, thanks.

I'm unsure if the following set up is OK since I can't test the difference. To charge up a batbox with basic solar panels(246:3), is it OK to place the solar panels together and while one sits on top of the batbox. Or do both solar panels each require to be connected via cables to the batbox?

It is. I expected a lever to work. Or even some sort of switch on the pipe, close to the machine, which interrupted the flow going into the machine. I suppose I could just break the pipe, that's the easiest thing to do. I'm not taking 9 stacks of seeds out of a squeezer every time I want to run...

Another off the topic question - it saves new threads. Is it possible to switch off machines like the squeezer and carpenter etc but still connected to a generator?