RotaryCraft hydrokinetic engine torque not stacking.

[Flamingtomatoes]

So im starting to get the hang of this mod and wanted to try putting down a few hydrokinetic engines. I was under the impression that one will put out @500 kw or torque at max and that each attached on would stack onto it so at 4 you would get @ 2mw of torque. However i seem to only be able to get @500kw. The three others hooked up are showing 0. all at 32 rads. the pic is what im talking about. note im in creative for troubleshooting. duno if that would do anything.

 

[Padfoote]

Put a dynamometer at the end rather than using the transducer to check. The transducer only shows the output for a single engine rather than all of them.

 

[Flamingtomatoes]

Put a dynamometer at the end rather than using the transducer to check. The transducer only shows the output for a single engine rather than all of them.

Awesome thank you, I had no idea XD. Don't feel like im getting it as well as i thought before XD