ME Level Emitter help

[Flexico]

I'm trying to use the level emitter to disconnect a portion of my ME system if the system energy level drops below 6,000,000 RF. However, I notice that ME systems can display power in a variety of units, such as AE, EU, and RF. Which one is used when inputting the number into the level emitter? I've messed around with it for a while, and no matter what I do it doesn't emit a signal, and sometimes WAILA says "device lacking channel" even though clicking with the Network Tool shows it on the list, and I know there's a channel open for it. What's going on?

 

[Bickers]

that is not what thay are designed for there meant to output redstone when above or below X amount of items in the system if you have ender io use a power monitor its capable of doing what you want

 

[Flexico]

Then what is the "energy" mode for?

 

[Bickers]

Then what is the "energy" mode for?

if i had to guess probably to emit redstone when above or below X amount of AE power within the controller/cells but if you want to turn off the system if you get to X power left in your capacitor bank/ TE cell its useless

 

[Flexico]

if i had to guess probably to emit redstone when above or below X amount of AE power within the controller/cells but if you want to turn off the system if you get to X power left in your capacitor bank/ TE cell its useless

Yes, that's exactly what I want. I have the redstone signal pointing to an ME toggle bus that ... ... OH I GET IT NOW. I had it set up to disconnect itself from the system when it emitted the redstone signal. THAT'S why I got the "no channel" error. HAH. My bad.