HELP: Automating Electrical Engines with Assembly Table

[crookfingerjake]

Hello folks, I can't seem to figure out how to auto-shutoff my electrical engines at my assembly table. I use six lasers with two upgraded electrical engines running 3 each. It runs marvelously but if I leave it unattended and it finishes production the center golden conductive pipe will eventually overload and blow up.

I can't seem to figure out how to use gates to prevent this, nor do I see any options for the laser/assembly table show up in the gate when placed on the gold pipes. Moreover I don't see a way to do this on the wooden pipe coming out of the engine.

What am I doing wrong?

 

[NTaylor]

I think if you put a gate next to the assembly table using a structure pipe and putting the gate on that and set it to has work then emit red (could use any colour I just said red) pipe wire signal (I believe you have to have an iron gate or higher to set that conditional also you have to run the wire for the conditional to show up in the gate) then run the red pipe wire all the way to your engines and put iron gates on them saying emit redstone signal if receiving red pipe wire signal then that should do exactly what you want it to do.

 

[crookfingerjake]

Indeed? I will try this forthwith and return with my results.

 

[crookfingerjake]

NTaylor! Your suggestion was perfect! It works a treat now! Can't thank you enough, you have saved the lives of so many gold conductive pipes!