Windows .exe [Forestry] Logger does not output wood

[madaffacca]

I have set up a pretty basic arboretum/logger system with a couple of peat fired engines; again, a really basic one, with just a couple of stone transport pipe coming out of the logger and endig up in chest two block away from the logger. After a couple hours of work, I checked the chest and found out that there were no wood inside. Plenty of saplings, few apples but not one single piece of wood.
Any clues about what in heck is going on?

 

[frederikam]

I have set up a pretty basic arboretum/logger system with a couple of peat fired engines; again, a really basic one, with just a couple of stone transport pipe coming out of the logger and endig up in chest two block away from the logger. After a couple hours of work, I checked the chest and found out that there were no wood inside. Plenty of saplings, few apples but not one single piece of wood.
Any clues about what in heck is going on?

I think saplings/apples/resin comes out from the top, and wood from the sides.

Edit: look at this from the forestry wiki:

Piping (Buildcraft)

Unpowered Output:

• Saplings (top/bottom)
• Apples (top/bottom)
• Logs (sides)

I hope that should answer everything, I am glad to help.

 

[madaffacca]

...That awkard moment when you feel the most stupid person all over the minecraft community.
Thanks a lot, mate!

 

[frederikam]

...That awkard moment when you feel the most stupid person all over the minecraft community.
Thanks a lot, mate!

No problem, i am just here to help